5 Printing 59
Printing envelopes
To print envelopes from a program
1 Load envelopes into Tray 1.
2 In your program or in the driver, specify Tray 1 or Automatic. Or, select the paper source.
3 Set the appropriate envelope size and type. For envelope specifications, see the introduce guide on the product CD, or go
to www.hp.com/support/lj9000
.
4 If your program does not automatically format an envelope, specify “Portrait” for page orientation.
CAUTION To avoid a jam, do not remove or insert an envelope after you begin printing.
5 Set margins to within 15 mm (0.6 inch) from the edge of the envelope. For best print quality, set margins for a return and
mailing address (typical address margins for a Commercial #10 or DL envelope are offered). Avoid printing over the area
where the three back flaps meet on the back of an envelope.
6 To print by type and size of paper, see the introduce guide on the product CD, or go to www.hp.com/support/lj9000
.
7 Select the Bin 1 as the output location, if you print envelopes to the stacker or stapler/stacker. If you print envelopes to
the multifunction finisher, select the Stacker bin as the output location.
8 When finished, return the fuser levers to the down position.
CAUTION Failure to return levers to the down position for standard paper types can result in poor print quality.
