F Administration tasks 248
Digital sending configuration applet
Digital sending configuration applet
To gain access to the embedded Web server digital sending configuration applet, follow these steps:
1 Open the embedded Web server.
2 Click the Settings tab.
3 Click Digital Sending.
Note You might be prompted to install a plug-in for your Web browser (the plug-in is required to run the applet).
The digital sending configuration applet of the embedded Web access server allows you to configure e-mail settings for
outgoing and incoming mail. This enables you to use “send and receive” capabilities. Through this page, you can:
z enable and disable the digital sending service and establish a maximum file size.
z set the SMTP address for digital sending.
z set an alias to be displayed in the From field to replace the full e-mail address.
z set the default Subject field.
z use advanced features:
establish fixed default Message Text.
establish default document settings.
z test digital sending settings using the screen Test button.
z configure LDAP addressing for digital sending.
LDAP addressing settings
The LDAP addressing settings:
z establish LDAP parameters to allow access to a centralized network address book.
z enable the Test button to verify configuration.
