A SERVICE OF

logo

B Control panel menus 194
Configure device menu
STAPLES=NONE Values vary
depending on
the output
device attached
If stapling is requested, indicates where the staple is placed and how many
staples are placed.
If a stacker is attached to the product, stapling is not an option.
If a stapler/stacker is attached, you can choose the following values:
NONE
ONE (upper-left corner)
ANGLED (upper-left corner)
TWO
THREE
SIX
CUSTOM (only if the stapler/stacker has a definition for custom)
OPPOSITE CORNER
Note Because of paper size, paper orientation, and paper feed
direction, you should experiment with staple options to
find the results you want.
If a multifunction finisher is attached, you can choose the following values:
NONE
ONE
TWO
SADDLE STITCH
Item Values Explanation