B Control panel menus 190
Paper handling menu
FUSER MODES AUTO
NORMAL
LOW
HIGH1
HIGH2
SPEED
Configure the fuser mode associated with each paper type.
The fuser mode can only be changed from this menu option in the
control panel.
AUTO: Utilizes the optimum mode for that media type.
NORMAL: Normal temperature, prints at 50 pages per minute (ppm)
(40 ppm for the HP LaserJet 9000Lmfp).
LOW: Low temperature, prints at 50 ppm (40 ppm for the
HP LaserJet 9000Lmfp).
HIGH1: Raises the temperature, prints at 50 ppm (40 ppm for the
HP LaserJet 9000Lmfp).
HIGH2: Raises the temperature, prints at 32 ppm.
SPECIAL: Mode to print at normal speeds with a 40-second delay
added to the beginning of the next job. After each 400 pages are
printed, the first page of that job is printed at a slower speed in order
to clean the fuser. No defects should be noticeable on the printed
page. This is not a preferred setting.
The default value for each paper type is AUTO.
For a complete list of supported paper types, see the introduce
guide on the product CD, or go to www.hp.com/cposupport/
.
CAUTION
If you change the fuser mode to HIGH1 or HIGH2, be sure to change it
back to the default when you are done printing. Setting a paper type
to HIGH1 or HIGH2 might shorten the life of some consumables, such
as the fuser, and might cause other failures or jams.
Item Values Explanation
