7 Problem solving 128
Understanding product messages
TRAY xx OPEN
alternates with
Ready
The specified tray is open or is not closed completely.
TRAY xx
SIZE=*SELECTED SIZE
alternates with
To change, move
switch in tray x
The custom switch is in the “standard” position, and a value from the menu is selected.
TOO MANY PAGES IN JOB
TO STAPLE
The job height is greater than the stapler capacity. The height of the job to be stapled should not
exceed 5.5 mm (0.22 inch).
Verify that the job is within specifications to be stapled. See the use guide that came with the
output device for more information.
TOO MANY PAGES TO
MAKE BOOKLET
The page content is too large to be saddle stitched.
Verify that the job is within specifications to be saddle stitched. See the use guide that came
with the output device for more information.
TYPE MISMATCH
TRAY x=[TYPE]
The system detected an overhead transparency in the paper path coming from the tray (xx).
UNABLE TO
MOPY JOB
A mopy job cannot be mopied because of a memory, disk, or configuration problem.
Only one copy will be produced.
If job name is unknown, insert UNTITLED.
Message Explanation or recommended action
