1–Remove:
– (E+/A0+-size model) The large box containing the stand and
paper bin. Two people may need to do this, as it’s rather large.
– The two packages containing documentation, cables, etc.
– The foam packaging that protects the ends of the printer.
C472301
2–Remove:
– The foam restraints on top of the printer.
– The vertical foam struts at the back of the packaging.
3–For E+/A0+-size models and if you have the
stand accessory with D/A1-size models, open the
box that contains the stand and the paper bin—it’s the
large box above the main printer body.
3–For D/A1-size models without a stand, go to
Stage 6: Locate the Front-Panel Overlay and the Pocket
Guide on page 4.
1–Separate the stand from the paper bin. Set
aside the cardboard tray inside which separates the
components of the paper bin from those of the printer’s
stand. This gives you access to the stand components.
2–Attach the legs to the outside of the cross
brace. Note that the stand is assembled upside-down.
You’ll find the screws and screwdriver inside the cross
brace.
3–Insert eight screws into the legs. Use the
smaller screws with washers.
4–Position the horizontal foot brace onto the
feet. Push the foot brace into the slot in each foot.
5–Position the feet on the legs assembly. The
wings on the leg brackets pass through the feet.
6–Secure the feet to the legs with ten screws.
Again, use the smaller screws with washers.
1–Check that all the stand screws are tight.
If you can’t tighten all the screws properly, try
unscrewing one or two so that the legs, feet and cross
braces are properly aligned, and then retighten them.
2–Put the stand assembly onto the printer.
Peel open the protective cover and then place the stand
onto the printer.
3–Secure the stand with the four screws that
have large flat heads.
Two screws (on one leg) are
secured normally.
CAUTION: Two of the screws on the same leg will
appear to be not fully tightened, as they will not go in as
far as the others—they should be firm but not over tight.
4–Ensure all four brakes are applied, as shown.
5–Tilt and lift the printer (1):
WARNING: 2–3 people for the E+/A0+-size model; 2
people for the D/A1-size model.
CAUTION: Ensure the area in front of the printer is clear
of any obstacles such as packaging or rolls of paper.
6–Tilt and lift the printer (2): Tilt the printer through
90-degrees onto its side, and then stand it up on its legs.
The printer may seem a little wobbly on one side, but
that is correct provided the screws have been tightened
as indicated in previous steps.
3. Assemble the Stand (E+/A0+-size models and accessory with D/A1-size models)
4. Attach the Stand to the Printer (E+/A0+-size models and accessory with D/A1-size models)
