Chapter 1 Introduction
1-7
No. Name of Parts Outline of Functions
1 Top Cover Assy
Stores the printed output. If required the additional
2 paper supports can be also used to support the
paper. The plate at the top can be raised and
secured.The paper stopper on the front can be
pulled out, the upright support raised and then
adjusted back to the required paper size.
2 Operator Panel
To configure and advise the status of the printer.
3 Front Cover
To gain access to the toner cartridges and waste
toner pack.
4 Rear Cover Assy
Transfers images onto the page and transports the
paper. May be required to be opened when clearing
internal jam or trouble shooting and when replac-
ing the fuser unit
5Top cover
Allows access to the OPC Belt Cartridge and trans-
fer belt cleaner.
6Power Switch
To power on or off the printer.
7 AC Input Inlet
To connect a power supply cable.
8Interface Control Box
Controller board with USB and Ethernet connec-
tors.
9/
10
Upper/Lower Duplex
Cover
To be removed only when installing the duplex
unit.
