1-20 Unpacking and Assembly
40. (Optional) Connect the optional VOC plenum to building
ventilation or VOC recovery equipment.
Install and connect the optional VOC plenum to a building
exhaust duct or charcoal filter device. Refer to the documen-
tation that accompanies the kit for instructions.
41. Level and stabilize the printer.
Leveling the printer and removing its weight from the stand
casters is required to ensure proper media tracking and
high-quality prints. Locate the printer on a flat, level floor.
Lower all four leveling feet so they contact the floor, then
continue lowering them until the printer’s weight is off the
casters. Next, use a bubble level to ensure that both legs are
level front-to-back by adjusting the leveling feet (raise the
lower end, and keep the printer’s weight off the casters).
42. In the accessory kit, locate the two turnbuckles marked “A”
and “B.”
Caution
Do not turn the nut on the turnbuckle. Turning the
nut will change the post-heater alignment. If the nut
is turned, the post heater will need to be re-aligned
to ensure proper media tracking.
43. From the rear of the printer, install the turnbuckle marked “A”
to the location behind the postheater marked “A,” using the
turnbuckle pins and ring clips.
44. From the rear of the printer, install the turnbuckle marked “B”
to the location behind the postheater marked “B,” using the
turnbuckle pins and ring clips.
45. Check the ground path between the takeup spool and the
electronics box.
Set your ohmmeter to check continuity at low voltage (to
measure resistance of no more than 3 or 4 ohms). Touch one
lead to the takeup spool and the other lead to the steel cover
of the electronics box. Manually turn the spool a few rota-
tions to make sure that the spool finger is engaged into the
supply & takeup shaft. A resistance reading greater than 2 or
3 ohms could indicate a ground path problem.
