A SERVICE OF

logo

Open as PDF
next previous
1-16 Unpacking and Assembly
Final Assembly 30. Install the vacuum reservoir (see Fig. 1-8).
Ensure that the o-ring is in place inside the reservoir open-
ing, and screw on the reservoir. Hand tighten firmly, but do
not overtighten.
31. Using the threading string attached to the stand leg, pull the
drain tube that is connected to the left-side spittoon through
the stand leg to the rear of the printer, and connect it to the
left-side excess ink reservoir (see Fig. 1-9).
Fig. 1-8. Vacuum reservoir
Fig. 1-9. Connecting the drain tube to the reservoir