A SERVICE OF

logo

Open as PDF
next previous
1-10 Unpacking and Assembly
Printer Assembly 15. Attach the lift handle to the left end of the printer, using four
#2 screws on the back and one screw on the front (see
Fig. 1-3).
16. Remove and discard the “DO NOT LIFT” label.
17. Detach the printer chassis from the pallet.
The printer chassis is attached with 10 mm hex-head bolts
and shock-absorbing washers to two wooden frames on the
pallet. Access the screws from the rear of the pallet.
18. Position the stand behind the printer.
19. Lift printer straight up and lower onto the stand legs (see Fig.
1-4).
Fig. 1-3. Lift handle