4-10 Manual Calibrations
◆ 10-inch calibration — prints a 10-inch test pattern so you
can verify its length with an accurate metal ruler. This is
not as precise as the 34-inch calibration, but it uses less
media. Measure and adjust the media advance as
needed until the pattern is exactly 10 inches long.
Tip
To avoid cutting the 10-inch pattern from the media
web, copy the marks from the 10-inch calibration to
the long edge of a letter-size (or A4) sheet of paper.
Then measure the transferred marks and adjust the
media advance as needed until the marks are exactly
10 inches apart.
Tip
Run the 34-inch or 10-inch calibration first, then run
the stitch pattern version to fine-tune the media
advance accuracy.
◆ Input MFN — enter the Media Feed Number that was
displayed after a previous media feed calibration, to
return to that setting without performing the calibration
again.
