HP Designjet 70/110plus Printer series—Quick Reference Guide
39
If there is a hardware error with your printer, this icon flashes on the front panel:
The precise error is indicated by a pattern of squares displayed in the ink cartridge
icons on the front panel.
Pattern Explanation Solution
Packaging not properly
removed, or printhead
carriage latch not properly
closed, or cutter badly
assembled
Error code: 86:11
Turn off the printer. Make sure that all
packaging is removed and that the
printhead carriage latch is properly
closed. Remove and reinstall the cutter
according to the instructions in the
User’s Guide.
Rear path not correctly
installed
Error code: 35:01
Remove the rear path, then reinstall it
(see page 32). You may have to press
the OK key to clear the error.
General printer system failure
Error code: 56:13
Unplug power cable, wait a few
seconds, plug in power cable and turn
printer on. If the problem persists, call
HP support.
General I/O failure
Error code: 65:04
Unplug power cable, wait a few
seconds. Connect alternative I/O if
available, plug in power cable, turn
printer on
The problem is a flashing tool icon in the front panel
