A SERVICE OF

logo

74 Removal and replacement EN
5 Separate the rear panel from the main cover, pulling the lower corners away from the printer first.
Then, insert the small flathead screwdriver into the openings at the top to pop the upper corners
(Figure 6-3, callout 1).
6 Remove the cover by grabbing it on both sides and pulling it straight back with a firm pull (Figure
6-3, callout 2).
Figure 6-3 Back Cover removal (2 of 2)
To reinstall
Make certain the Input Extender is raised before you reinstall the back cover.
2
1
Service.book Page 74 Thursday, September 14, 2000 11:15 AM