HP Jetdirect EIO Control Panel Menus 39
ENWW
CFG IPX/SPX= Selects whether you want to access the IPX/SPX menu
and set IPX/SPX protocol parameters.
● NO (default): Bypass the IPX/SPX menu items.
● YES: Access the IPX/SPX menu items.
In the IPX/SPX menu, you can specify the Frame Type
parameter used on your network.
■ AUTO (default) will automatically set and limit the frame
type to the first one detected.
■ For Ethernet cards, frame type selections include
EN_8023, EN_II, EN_8022, EN_SNAP.
.
CFG LINK=
Selects whether you want to manually configure the
HP Jetdirect print server’s network link.
● NO (default): Bypass the link configuration menu
items.
● YES: Access the link configuration menu items.
One of the following link configurations can be set:
■ AUTO (default): The print server will automatically
configure itself to match the network’s link speed and
communication mode. If it fails, 100T HALF is set.
■ 10T HALF: 10 Mbps, half-duplex operation.
■ 10T FULL: 10 Mbps, full-duplex operation.
■ 100T HALF: 100 Mbps, half-duplex operation
■ 100T FULL: 100 Mbps, full-duplex operation
WEB= For configuration management, specify whether the
embedded Web server will accept communications
using HTTPS (Secure HTTP) only, or both HTTP and
HTTPS.
● HTTPS: For secure, encrypted communications,
only HTTPS access is accepted. The print server
will appear as a secure site.
● HTTP/HTTPS: Access using either HTTP or
HTTPS is permitted.
SECURITY= Specify whether the current security settings on the print
server will be saved or reset to factory defaults.
● KEEP (default): The current security settings are
maintained.
● RESET: Security settings are reset to factory
defaults.
Table C-1. EIO Classic Control Panel Menu (3 of 3)
Menu Item Description
EIOSG.book Page 39 Thursday, October 9, 2003 1:42 PM
