3.3 Auto Layout 33
Determining the Scaling Factor
During execution of auto scaling, the scaling factor is determined by the document size and
output size. Note that the scaling factor depends on the [Zoom Mode] setting.
Note
• To enable the scaling function, set [Zoom] to [On] on the control panel. If [Zoom] is set at [Off], images
will be drawn at a scale of 100%.
When [Document Size] Is Set to [Auto] and [Zoom Mode] Is Set to
[Output Size]
The [Hard Clip] setting becomes ineffective. The output size hard clip area is always used.
• When the document size is the same as the output size, the image is drawn at a scale of
100%.
• When the document size is larger than the output size, the image is drawn with it reduced.
• When the document size is smaller than the output size, the image is drawn at a scale of
100%.
Note
• When origin position is set to layout, the image is drawn with the document laid out at the center. When
origin position is set to bottom left or center, the image is drawn with the origins of the document and
paper aligned.
• Some output sizes may not be used depending on the printer type.
Output size
Document
A3 A4 A5 B4 B5
A0 35 25 100 31 100
A1 50 35 25 43 31
A2 71 50 35 61 43
A3 100 71 50 87 61
A4 100 100 71 100 87
A5 100 141 100 173 100
