SECTION 2
INSTALLING THE PRINTER
5
Section 2 – Installing the Printer
Before using the printer the following must be done:
• Choose a location for the Printer
• Plug in the printer and connect it to the computer
• Install the Inkjet Cartridges
• Set up the feed on the printer
• Install the ASTROJET 2600P/2800P Printer Driver software on the computer
Choose a Location
The printer should be placed on a sturdy worktable or cabinet at least 12 inches from any walls. Protect the
printer from excessive heat, dust, and moisture – avoid placing it in direct sunlight.
Connecting the Printer
Plugging in the Printer
Make sure that the main power switch of the AstroJet 2600P/2800P Printer is in the OFF position.
1. Connect one end of the power cord to the rear of the
AstroJet 2600P/2800P in the corresponding
receptacle.
2. Depending on the version 115 volt or 220 volt, plug
the other end into a 115 or 220 Volt AC, 50/60 Hz.
Grounded outlet.
CAUTION
Do not use an adapter plug or extension cord
to connect the printer to the wall receptacle.
Do not use outlets controlled by wall switches.
Do not use an outlet that shares the same
circuit with large electrical machines or
appliances.
Connecting to the Computer
Plug the parallel printer cable from your computer into the
rear of the printer and latch the two locking clips. You may
also connect the printer through a USB connection if you are
using Windows ME, 2000, NT, or XP. The cable used to
connect the AstroJet 2600P/2800P to the computer must
not exceed 6 feet long.
