A SERVICE OF

logo

Open as PDF
next previous
Removal and Replacement of Parts (without Calibration) 7-47
Replacement of Parts
Installing the Absorber
Step 1. Replace the absorbers into position.
Step 2. Gently slide the new service station into the printer until the screw holes are aligned.
Step 3. Replace the service station connector. Ensure that it is properly plugged in.
Step 4. Replace the three screws at the top of the service station in order (that is, replace number one,
followed by two and then three).
Step 5. Replace the remaining components for the Ink Supply Station (refer to the procedures in Installing
the Ink Supply Station from Replacement of Ink Supply Station).