User's Guide 28
System Level Commands
Command Description Remarks
<STX>a Enable page/job echo characters
<STX>cxxxx Set continuous paper length and
disable edge sensor
<STX>Dxxxxxxx Memory dump
**
xxxxxxx : memory address in
HEX value
<STX>Exxxx Set copy count for stored label
<STX>e Enable edge sensor
<STX>F Feed a page
<STX>fxxx Back feed from top position
<STX>G Print stored label
<STX>I Download graphics either PCX, BMP, PCX
or HEX format
<STX>J Set pause for each label
<STX>j Cancel pause
<STX>KQ System configuration details
<STX>L Enter label formatting state
<STX>Mxxxx Set maximum label length
<STX>m Set measurement in metric
<STX>n Set measurement in inches
<STX>Oxxxx Set start of print position
<STX>P Enable data dump
<STX>Q Clear memory (fonts & graphics)
<STX>r Select reflective sensor
<STX>Sn Set feed rate for motor n : ‘A’, ‘B’ or ‘C’
<STX>T Print test pattern
<STX>Vn Set Cutter or Peel and Present
configuration
n : ‘1’ - enable cutter,
‘4’ - enable peel and
Present
<STX>v Printer version information
<STX>Wn Graphics/fonts/labels and memory
status details
n : ‘G’, ‘F’ or ‘L’.
RS-232 port only
<STX>x Release file from printer memory
Note:
**
Models FM402DT and FM402TT, the memory dump command only needs a 6-digit
hexadecimal.
