how to remove or disable

Asked by tom on 03/24/2014 1  Answer

ManualsOnline posted an answer 10 years, 8 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
5 Ok so the valet switch should be a "toggle" paddle switch. I've never seen a push button one. It is usually made accessible from the drivers seat. I would check just below the steering wheel because 9/10 times that's where it is installed. If not there I would check around centre console and in it. It has a black wire leading to it. It is 1 single wire going into it. If you want to remove the alarm completely it is usually located on the steering wheel column. It is very easy to notice. It will have 1 wire harness with approx 10 wires in 1 harness and a single wire harness and a 2 wire harness. It will look very out of place. Usually zip tied around the steering wheel shaft. The only other common spot for it is behind the drivers side kick panel on the floor. If it was installed unprofessionally It may just be loose hanging around in there. It is almost always located on the drivers side. To disable it just unplug all harnesses from it and you won't need to worry about it again. Another easy way to find the location for it is to look under your hood and find the loud horn speaker for it. Make note of the color of the 2 wires lead into it. Look along the firewall for 2 wires of the same color that look out of place and this will lead you to the "brain". From there you can find the single wire input for the valet switch that will lead you to the valet. Please note that I have seen many systems where the customer didn't want a valet switch installed. So your car may not even have the switch installed. If you have any questions just shoot me a message. Good luck! -Anthony
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.