Filter
Top Products
8-6
6. Insert the dipstick into the oil filler hole,
and then tighten the engine oil filler cap.
To change the engine oil (with or without
oil filter element cleaning)
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes,
and then turn it off.
3. Place a container under the engine to
collect the used oil.
4. Remove the engine oil filler cap, and then
remove the engine oil drain bolt to drain
the oil from the crankcase.
CAUTION:
_
When removing the engine oil drain bolt,
the compression spring, oil strainer and
O-ring will fall out. Take care not to lose
these parts.
_
NOTE:
_
Skip steps 5–9 if the oil filter element is not be-
ing cleaned.
_
1. Engine oil drain bolt 2. O-ring
3. Compression spring 4. Engine oil strainer
U5YT10.book Page 6 Friday, December 12, 2003 2:32 PM