Filter
Top Products
INSTRUMENT AND CONTROL FUNCTIONS
3-17
3
EAU44582
Auxiliary DC connector
To access the auxiliary DC connec-
tor
1. Remove the rider seat. (See page
3-11.)
2. Unhook the battery band, and then
remove the battery cover.
3. Turn the ECU (Electronic Control
Unit) over to move it away from the
wire harness protective cover as
shown.
4. Open the wire harness protective
cover.
A 12-V accessory connected to the
auxiliary DC connector under the rider
seat can be used when the key is in the
“ON” position.
CAUTION:
ECA15310
The accessory connected to the
auxiliary DC connector should not
be used with the engine turned off,
and the load must never exceed 36
W (3 A), otherwise the battery may
discharge.
WARNING
EWA12531
To prevent electrical shock or short-
circuiting, make sure that the cap is
installed when the auxiliary DC con-
nector is not being used.
1. Battery band
2. Battery cover
2
1
1. Wire harness protective cover
2. ECU (Electronic Control Unit)
1. Auxiliary DC connector
2
1
U29S10E0.book Page 17 Friday, May 18, 2007 1:53 PM