Filter
Top Products
INSTRUMENT AND CONTROL FUNCTIONS
3-12
3
and release this switch after start-
ing the engine to enable hand
shifting.
EAU40492
Shift pedal
This vehicle is equipped with a con-
stant-mesh 5-speed transmission. The
shift pedal is located on the left side of
the engine. Neutral is at the bottom po-
sition.
NOTE:
It is impossible to shift gears unless the
main switch is in the “ON” position.
The shift pedal can be adjusted to three
positions to suit the rider’s preference.
To adjust the shift pedal position
1. Remove the shift pedal by remov-
ing the bolt.
2. Move the shift pedal to the desired
position.
3. Install the bolt, and then tighten it
to the specified torque.
1. Shift pedal
1. Shift pedal
2. Bolt
3. Standard position
Tightening torque:
Shift pedal bolt:
6.5 Nm (0.7 m·kgf, 5.0 ft·lbf)
U2D212E0.book Page 12 Wednesday, October 17, 2007 5:01 PM