Filter
Top Products
OPERATION
Power On And Self-Test
Each time your Whistler detector is turned on, an auto-
matic self-test sequence confirms that the speaker and
visual displays are functional.
• Press Power or apply Power. Display reads:
Self-test Mute
Simply press the Quiet button during the self-test
sequence to cancel the self-test audio. This will not effect
radar/laser alerts. To restore the self-test audio, simply
press the Quiet button during the next self-test.
Integrated Real Voice
When selected, Real Voice will be used to articulate the
following:
1.Band Identification
2.Safety Warning System messages
3.Feature Selection
9
INSTALLATION
Visor Mounting (optional accessory )
• Slide the visor bracket into the bracket mounting slot.
• Clip the visor bracket onto the visor making sure it is
relatively level and has a clear view of the ro a d .
Power Connection
• Plug the small end of the power cord into the unit’s power
j a c k .
• Plug the large end into the vehicle’s cigarette lighter.
Fuse Replacement
The lighter socket plug is equipped with a replaceable 2
amp 3AG fuse located behind the silver tip. To replace the
fuse, carefully unscrew the tip of the plug. (I M P O R TA N T:
U n s c r ew slowly. The tip contains a spring which may fly out
when disassembling.) Insert the new fuse with the spring and
s c rew on the tip. With use, screw cap on plug may loosen.
Retighten occasionally.
U n s c r ew the tip of the lighter socket plug carefully when replacing the 2 amp
f u s e .
8
Insert into bracket mounting slot. Do not bend this
section of bracket.
Slide on view
1740/1745 manual 3/6/02 2:17 PM Page 11