Volvo 240 Automobile User Manual


 
1987 Volvo 240
Jump starting
CAUTION: Improper hook-up of jumper cables or the use of other than 12 volt batteries could result in
damage to equipment and/or battery.
Check that cars are not touching to prevent premature completion of negative circuit.
Note the position of the battery terminals. When using jumper cables, first connect booster battery
positive (+) terminal to car battery positive (+) terminal. Then connect booster battery negative (-)
terminal to a stationary solid metal part on the engine at a point away from the battery. Do not connect
booster cable to any part of fuel system or any moving parts. Avoid touching hot manifolds.
WARNING!
To prevent possible explosion, never expose battery to open flame or electric spark. Do not smoke
near battery. Batteries generate hydrogen gas which is flammable and explosive.
Battery fluid contains sulfuric acid which can cause serious injury.
Do not allow battery acid to contact eyes, skin, fabrics or painted surfaces. If contact occurs,
thoroughly flush affected area immediately with water. Obtain medical attention immediately if eyes
are affected.
After engine has started first remove negative (-) jumper cable, then positive (+) terminal jumper cable.
pg. 74 Replacing bulbs
file:///K|/ownersdocs/1987/1987_240/87240_03b.htm (8 of 23)12/30/2006 7:53:31 AM