Filter
Top Products
12
©
1999 Directed Electronics, Inc.
To perform Valet Take-Over:
1. Before turning off the engine, press and release and
on the transmitter (or press and release the optional Momen-
tary switch).
2. Turn the ignition key to the OFF position.
(The engine will stay running.)
3. The engine will run until the pre-programmed time elapses or
a shut-down input is received. (See the previous Remote Start
section for a complete list of shut-down inputs.)
NOTE: This feature will not work if the brake pedal is being pressed.
This remote start system is also designed to interface with most
original equipment from manufacturer (OEM) factory remote sys-
tems. The Remote Start/Valet Take-Over sequence can be pro-
grammed to initiate with one to three (1-3) presses of one of the
OEM transmitter buttons. Consult with your dealer to determine
the transmitter button and the number of presses (1-3) that have
been programmed for this sequence. Spaces are provided below for
writing in the button and number of button presses.
OEM transmitter button used for Remote Start/Valet Take-Over
sequence____________________________________________
Number of presses required to initiate Remote Start/Valet
Take-Over sequence___________________________________
Using Remote Start with Factory Remote Systems