PAGE 1 OF 19
Valvcon Corporation
http://www.valvcon.com
phone: 603-249-9020 fax: 603-249-9140
INSTALLATION GUIDELINES
AND OPERATING PROCEDURES
for
115VAC V-SERIES ELECTRIC ACTUATORS
This instruction manual contains important information regarding the installation,
operation and troubleshooting of Valvcon's V-Series Electric Actuators. Please read
these instructions carefully, and save them for future reference.
INSTRUCTION MANUAL P/N 1800 Rev. F
08/04/2003
Valvcon electric actuators are manufactured in Milford, NH. They are configured, sold and serviced by a
world-wide network of qualified Stocking Representatives. The Stocking Representative may ask Valvcon
to drop-ship actuator(s) directly to a customer. It is important to note that the unit(s) have not been pre-
calibrated and will require set up and tightening not necessarily limited to the following: limit switch
cams, centering of feedback potentiometers, as well as board level adjustments of jumpers, dip switches
and/or potentiometers. For technical assistance or further information, please visit our Worldwide Web site
at http://www.valvcon.com, or contact your local Valvcon Stocking Representative. Our Web site can also
hel
ou to identif
our local stockin
re
resentative.
TM
