Filter
Top Products
1994 TOYOTA TRUCK WITH 4 CYL. ENGINE
THROTTLE LEVER ADAPTOR PACKAGE
250-3642
1. Remove the throttle shaft nut and lock washer from the throttle shaft. Install
the Throttle Lever Bracket. Reinstall the lock washer and hex nut. NOTE:
Start the nut by hand to prevent cross-threading. Do not over tighten.
2. Install the Snap-in adapter from the cruise control kit onto the cruise control
cable. NOTE: A minimum of 1/8" of the cruise control cable must be exposed
past the end of the snap-in adaptor. See Figure 1.
Nut & Lockwashel
Ass'y 1/4"-20
Adaptor-Throttle
~ Threaded Snap-In
Module Cable MUST Extend Past Ada?tor
3. Install the cruise control cable bracket on vehicle accelerator cable bracket by
loosening only the REAR accelerator cable nut and inserting the cable bracket
between the nut and vehicle accelerator cable bracket. Retighten the accelera-
tor cable nut.
4. Install cruise control cable into cable bracket by pushing the snap-in adaptor
into the square hole of the cable bracket.
Form 2645
6/94