Spin Master Zero Gravity Micro Motorized Toy Car User Manual


 
FOR INDOOR USE ONLY.
ADULT SUPERVISION RECOMMENDED!
TO GET THEMOSTOUT OF
YOUR ZERO GRAVITY MICRO
WALLRACER PLEASE READ THESE
INSTRUCTIONS FIRST!
NOTE:
USE ON SMOOTH, CLEAN
SURFACES ONLY!
Check to make sure contents are
complete:
1 Zero Gravity Micro™ Wall Racer
1 Controller/Charger
1 Instruction Sheet
INSTRUCTIONS
TM
®
INSTALL BATTERIES
CLOSE
OPEN
Controller/Charger
Battery
Compartment
Door
Six
1.5-V AA
Alkaline
Batteries or
Rechargeable
Batteries
Battery
Compartment
CHARGING YOUR ZERO GRAVITY MICROWALL RACER
1. Switch
car to
“OFF”.
3. Take
out
charge
nozzle.
4. Plug cable
into port
of vehicle.
Make sure
the arrow is
on top.
6. Green light
flashing: Vehicle
is charging.
Green light off:
Vehicle is charged.
Charging should take between 30 and 50 minutes depending on how much charge is left in car.
NOTE: Do not charge battery immediately after use. Let car battery cool for at least 10 minutes. If charging is not complete in 50 minutes,
replace the charger batteries.
Your Zero Gravity MicroWall Racer has a pre-installed rechargeable
battery inside the vehicle body.
2. Switch
controller/
charger to
“OFF”.
5. Slide
switch on
controller/
charger to
CHARGE”.
7. When charged,
turn controller/
charger switch
OFF”.
8. Stow
charge cable
in storage
compartment.
PROBLEMS? Before you return to retailer, please call our HOTLINE for assistance,
1-800-622-8339
Zero Gravity Micro
Wall Racer
Controller/Charger