Filter
Top Products
G 40RS - Page 7
Jumper Selection
Carefully separate the top and bottom halves of the main unit case. Once the cover is removed, the parking
light polarity jumper will be visible next to the parking light relay. Set the jumper for the correct polarity
output as described below, then reassemble the main unit case.
Parking Light Output. Selects the polarity (+/-) for the output of the on-board Parking Light relay.
Left Pin + Center Pin = positive
Right Pin + Center Pin = negative
Branch Feature Button 1 (default) Button 2 Button 3
1. Ignition Door Locking Enabled Disabled
2. Ignition Door Unlocking Enabled Disabled
3. Door Unlock Pulse Single Double
4. Door Lock Pulse Length 1 second 3 seconds 0.1 Sec
5. Lock after Start On Off
6. Lock after Shutdown On Off
7. Engine Run Time 15 minutes 25 minutes
8. Automatic Start Mode Disabled 2 hours 1 hour
9. Tachless Sense Crank Time Normal Extended Super Extended
10. Engine Type RPM Mode/RPM Learn Gas Engine Diesel Engine
11. Ignition 2 Output Program Ignition 2 Output Accessory 2 Output Starter 2 Output
12. Unlock Before Start Disabled Enabled
13. Horn Chirp Enabled Disabled
14. Smart Start Run Monitor Enabled Disabled
15. Trunk Release/ Horn Out Trunk Release Horn Output
System
Programming
default setting shown