Razor MX500 15128190 Motorcycle User Manual


 
1 Using a 5mm hexagonal
key wrench, remove bolts
from handlebar clamp.
2 Place handlebars in handle-
bar clamp and adjust angle
parallel to the fork.
3 Insert bolts and tighten
securely. When properly
tightened, the handlebars
should not move forward or
back.
Attaching the Handlebars
WARNING:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to
lose control and crash.
4
1 Align bolt in fender with
hole in fork. Insert bolt
through hole in fork and
secure with nut.
2 Remove screw from front
fork assembly. Align hole in
number plate with hole in fork
assembly. Insert and tighten
screw.
Attaching the Front Fender and Number Plate
ASSEMBLY AND SET-UP
Installing the Front Wheel – MX500 / MX650
2 Make sure ball bearings are inserted in the wheel hub. Slide
axle through fork, spacer washer and though wheel hub. When axle
passes through the other side of the wheel hub, add the other spacer
washer and slide though the fork. Secure with washer and nut.
Note: Front axle is installed with the spacer washers between
the fork and wheel for all Dirt Rockets. If your model has one short
spacer, it goes on the side of the hub with the disc brake.
1 Position wheel in front fork
and slide disk brake into caliper.
Nut
Washer
Axle
Fork
Spacer Washer
Ball
Bearing
Disc
Brake
Small Spacer
Washer
Wheel