Filter
Top Products
3
ASSEMBLY AND SET-UP
Attaching the Front Forks
1
Insert the spacer sleeves on
the top and bottom of the frame.
2
Slide the fork into position
and insert the steering bolt.
The bolt must go through the
washer and spacer sleeve and
between the steering bearings
inside the frame
.
WARNING:
Failing to
properly adjust and tighten the
clamps and retainers that affi x
the forks can cause you to lose
control and fall.
3
Install washer and nut onto
steering bolt. Tighten until snug,
then back off slightly to allow
the steering to rotate freely with
no binding or end-play.
Charging the Battery
Your electric chopper may not have a fully charged battery. Th
erefore it
is a good
idea
to charge the battery
prior to use.
•
I
nitial charge time: 12 hours •
Run time: up to 40 minutes
• Recharge time: up to 8 hours •
Average battery life:
250 charge/discharge cycles
depending on the level of depletion.
1
P
lug the charger port
into
the port on the chopper.
The
charger works with the power
switch in either the on or off
position.
2
P
lug the charger plug into a
wall outlet.
WARNING:
A
lways
disconnect
your electric
chopper from the charger
before cleaning with liquid.
Note:
If your charger does
not look like the one illustrated,
your unit has been supplied
with an alternative charger. The
specifi cations and charging
procedure would not change.
The charger has a small
window with one LED or two
LEDs to indicate the charge
status. Refer to the illustration
on the charger unit for the
actual “charging” and “charged”
status indications for your
model charger.
C
hargers have built-in over-
charge protection to prevent
battery from being over-
charged.
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.
Charger
Plug
Charger
Port
Steering Bolt
Spacer Sleeve
Washer
Nut
Top Fork Crown
with Pinch Clamps
Fork
Lower Fork Crown
with Pinch Clamps
with Pinch Clamps
with Pinch Clamps
Spacer Sleeve
Spacer Sleeve
Spacer Sleeve
Washer
Spring But
tons
Holes for Spring
Buttons
with Pinch Clamps