Razor 15130412 Motorcycle User Manual


 
3
ASSEMBLY AND SET-UP
q Charging the Battery
Your Sport Mod may not have a fully charged battery; therefore you must charge the battery prior to use.
Initial charge time: 12 hours • Run time: up to 40 minutes
Recharge time: up to 8 hours • Average battery life: 250 charge/discharge cycles
Fully charge once a month when not in use • Do not store below 32 degrees - this can damage the battery.
1 Plug the charger port into the
port on the Sport Mod. The charger
works with the power switch in
either the on or off position.
2 Plug the charger plug into a wall
outlet.
WARNING:
Rechargeable batteries are only to
be charged under adult supervision.
Always disconnect your Sport Mod
from the charger before cleaning
with liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual “charging” and
“charged” status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.
Charger
Plug
Charger
Port
WARNING: Failing to
properly adjust and tighten the
clamps and retainers that affix the
handlebar can cause you to lose
control and fall.
1 Loosen the two hexagonal
bolts with the 3mm hexagonal
wrench and remove the plastic
handlebar cover.
2 Insert handlebar assembly into
the fork until it stops. Raise to
desired height, keeping the stem
and fairing aligned within the red
arrows of the safety zone.
q Attaching the Handlebars
3 Tighten down the hexagonal
bolt with the 6mm hexagonal
wrench.
4 Put the plastic handlebar
cover back in place.
5 Secure the two hexagonal bolts
with the 3mm hexagonal wrench.