Raymarine DSM300 GPS Receiver User Manual


 
14 DSM300 and DSM30 Installation Manual
1.5 Cable Runs
Consider the following before installing the system cables:
You will need to attach power, transducer, and display cables.
All cables should be adequately secured, protected from physical damage,
and protected from exposure to heat.
Avoid running cables through bilges or doorways, or close to moving or hot
objects.
Avoid sharp bends.
Use a watertight feed-through wherever a cable passes through an exposed
bulkhead or deckhead.
Secure cables in place using tie-wraps or lacing twine. Coil any extra cable
and tie it out of the way.
1.6 System Connections
The connector panel provides the following connection sockets:
T/D, 7-pin socket for connecting to the transducer
HSB2, 4-pin socket for connecting to a C Series or hsb
2
PLUS Series display
POWER, 3-pin socket; two for connecting to boat’s DC power and one RF
ground (screen) connection
SEATALK HS, RJ-45 socket for connecting to an E Series display
CAUTION:
To protect exposed pins, please place the attached dust cover
over the socket (4-pin or RJ-45) to which you are not connecting a
cable.
D7464-2
10.7 to 18 VDC (DSM30)
E Series Display
Transducer
C Series or hsb PLUS
2
10.7 to 32 VDC (DSM300),