Raymarine A65 GPS Receiver User Manual


 
Chapter 4: Using the Chartplotter 83
Note:
If you are removing a waypoint from an active route (a route that you are currently
following), the change does not take effect until after you have halted the route by pressing
STOP FOLLOW.
CAUTION:
When you remove waypoints from a route, the stored route joins
the two waypoints on either side of the waypoint just eliminated.
Ensure that this altered route does not present a navigation
hazard.
... to relocate a waypoint within the route
This option alters the course of a route by changing the order in which you travel
to the waypoints in the route:
1. Access the Make Route screen using the method described in the previous
section “... to add a waypoint”.
2. Use the trackpad (up) to highlight the new waypoint you want to move.
3. Press REMOVE WAYPOINT. The selected waypoint disappears from the list.
4. Use the trackpad to move the highlight immediately below the position
where you want the waypoint to be relocated.
5. Move control back to the left column and re-select the waypoint that you just
removed from your route.
6. Press INSERT WAYPOINT. The waypoint is returned to the route in the new
position.
7. Press SAVE ROUTE.
Note:
If you are moving a waypoint in an active route (a route that you are currently fol-
lowing), the change does not take effect until after you have halted the route by pressing
STOP FOLLOW.
Using the Cursor On Screen
... to add a waypoint
This option changes the course of a route by adding a new waypoint or
incorporating an existing waypoint to the end of the route:
1. Select the appropriate route for editing via the REVIEW & EDIT ROUTES soft
key.
2. Press AMEND ROUTE COURSE. The cursor is joined to the last waypoint in the
route with a dashed line.