Filter
Top Products
50 A65 GPS Chartplotter
5. When you arrive at the target waypoint an alarm sounds and a warning mes-
sage is displayed. To de-activate this alarm, press any key.
6. To set the cross track error (XTE) to zero and move the origin to the actual ves-
sel position press RESTART XTE. The BOD and BVD lines are now aligned.
7. To stop navigating to the waypoint, press STOP GOTO. The BOD and BVD lines
are removed.
Note:
For more information on navigation, see Chapter 4: Using the Chartplotter.
Navigating to a Waypoint Sent by NMEA
You can go to a waypoint that you have imported from another device (such as
another Raymarine display) via NMEA. The waypoint appears on the A65 display
just as if it were located in the A65’s own waypoint database.
1.0nm North-Up Relative Motion
Position N 25°18.160 W 080°19.397 -.-°T 0.0nm
D8636-2
WPT 0005
STOP GOTO
STOP GOTO
RESTART
TE
RESTART
TE
Bearing from Origin to Destination:
dashed line marking original
course of GOTO (unchanged)
Bearing from Vessel to Destination:
dashed (blue) line marking actual
current course of GOTO (updated)
Target Waypoint