Filter
Top Products
10
Installation
Fig. 2-7
Installing the
Sidelooker
Transducer
Mounting the Optional Sidelooker Transducer
1. The Sidelooker transducer allows the display unit to check the water
to either side of the boat. This is helpful when you are looking for fish
near river banks, or under docks or piers.
2. The Sidelooker transducer is attached to the same mounting bracket
used with the transom-mount transducer. See Fig. 2-7. Begin by
installing the transom-mount bracket as described earlier.
3. Attach the Sidelooker transducer to the top of the transom mounting
bracket. Use the four panhead screws supplied. The fit should be
snug, but do not overtighten the screws.
4. If you are installing the optional Sidelooker transducer, there will be
two
transducer cables. Run the second cable beside the cable for
the transom-mount transducer.
Installation Notes – Thru-Hull Transducer
Detailed instructions for this installation will be included with the trans-
ducer. In this section, we will note just a few important points.
1. Earlier we listed three general rules for placing transducers. All of
these rules apply when you are mounting a thru-hull transducer.
Here are some other rules for selecting the best mounting location: