Radio Shack Custom RC Motorized Toy Car User Manual


  Open as PDF
of 4
 
wwwwww
wwwwww
www
.xmodsRC.com.xmodsRC.com
.xmodsRC.com.xmodsRC.com
.xmodsRC.com
44
44
4
6
Remove the bevel gear by pulling forward and lifting
up. Hold the center shaft in place as you remove the
gear to hold it in place.
7
Use a narrow, flat bladed screwdriver to gently remove the
plastic bushing and replace it with a metal ball bearing.
Bevel Gear
Bearing
8
This completes the installation of the front bearings.
Reassemble the car by following Steps 1-7 in reverse
order and steps 1 and 2 under Preparing for Your
Metal Bearing Upgrade.
5
Remove the two plastic bushings and replace them with
two metal ball bearings.
Bearings
Steps 5 and 6 apply only to cars with an all wheel drive assembly.
If you do not have an all wheel drive assembly, proceed to Step 7.
Tip: When reassembling, align
the center shaft’s D-cut
with the D-cut in the gear.
Front End of Chassis
 previous