Radio Shack 60-8512 Motorized Toy Car User Manual


 
wwwwww
wwwwww
www
.xmodsRC.com.xmodsRC.com
.xmodsRC.com.xmodsRC.com
.xmodsRC.com
22
22
2
7
Remove the four screws from the rear lower deck to
release the rear arm base and detach the rear arms.
8
Disassemble the axle to access the six plastic
bushings. Replace each plastic bushing with a
metal ball bearing.
Rear Arm Base
Rear Lower Deck
9
This completes the installation of the rear bearings.
Reassemble the rear section of the car by following Steps
1-8 in reverse order.
5
Remove the two screws beneath the chassis that secure
the center shaft holder in place. Use a narrow, flat bladed
screwdriver to remove the plastic bushing from the
center shaft holder and replace it with a metal ball
bearing.
Remove plastic
bushing and replace
with metal bearing
Center Shaft Holder
Rear Arms
6
Remove the four screws from the rear arms to
release the rear support arms.
Bearings
Tip: When reassembling,
align the axles with
the D-cut in the
differential gear.