Radio Shack 60-8506 Motorized Toy Car User Manual


 
www.xmodsRC.com 1
elbaTwercS
wercS
noitacoL
raeRdnatnorF
srepmaD
reppUtnorF
)gnol(kceD
reppUtnorF
)trohs(kceD
thgiRdnatfeL
selkcunKtnorF
rewoLtnorF
kceD
reppUraeR
)trohs(kceD
reppUraeR
)gnol(kceD
rewoLraeR
kceD
rebmuN 42224424
XMODS
TM
Custom RC
All Wheel Drive Kit 60-8506
Upgrade your XMODS custom RC from standard two-wheel drive to all-wheel drive for improved traction
and cornering. Before installing this kit, turn off your vehicle and controller, and detach the car body.
The All-Wheel Drive kit includes:
Rear differential gear
Drive shaft cone gear
Front left and right steering assembly w/differential gear
Left and right rear arms (optional installation)
Tube of grease
1
Use the lug wrench supplied in your XMODS
TM
Starter Kit to
detach the front lug nuts and wheels.
2
Loosen and remove each damper screw and detach the
right and left front and rear dampers.
Note: Although the front and rear differential gears appear similar,
they are not. DO NOT USE THEM INTERCHANGEABLY! In the
event of mix up, carefully unscrew one gear into two halves.
If the gear has metal bearings inside, this is the rear
differential. If not, the gear is the front differential.
1
Loosen and remove each screw beneath the right and left
front knuckles. Loosen and remove the four screws
beneath the front arm base.
2
Unscrew and remove the two rear screws on the front upper
deck. Lift up and remove the front upper deck along with
the left and right steering assemblies.
Preparing for Your All-Wheel Drive Upgrade
Front Section All-Wheel Drive Installation
Note: You will not need the front left and right steering
assemblies unless you encounter a need to remove
the all-wheel drive upgrade.
Tip: You may find it useful
to remove the antenna
from the chassis.
©2003 RadioShack Corporation
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.