Polaris Offroad Vehicle Offroad Vehicle User Manual


 
Congratulations on the purchase of your Interactive Toy Concepts Polaris RUSH Snowmobile.
This snowmobile is made for indoor or outdoor use – even on snow!
For best performance operate on flat packed snow or switch to the indoor skis for great performance on carpet and other surfaces.
-PLEASE READ THIS INSTRUCTION MANUAL BEFORE OPERATING YOUR RADIO CONTROL SNOWMOBILE!
INSTRUCTION MANUAL
AGE RATING: 8+
To prevent damage during shipping the Polaris RUSH Snowmobile is securely fastened in the package.
Please ensure that all of the tie down and fastening locations are unfastened before attempting to remove the snowmobile
Take care to ensure snowmobile antenna has been detached from packaging before removing the snowmobile.
UNPACKING AND CONTENTS
RC
Antenna
Wheels
Indoor Skis
1. Use a Phillips screw driver to unscrew the battery compartment door
on the back of the Controller.
2. Install one (1) 9 Volt alkaline battery (not included) as shown into the
battery compartment.
3. Replace the battery compartment door and re-tighten the screw.
4. Turn the controller ON and ensure the power LED illuminates.
BATTERY INSTALLATION
Web site: www.interactivetoy.com
PLEASE! DO NOT RETURN THIS
PRODUCT TO ANY RETAIL STORE!
PLEASE! DO NOT RETURN THIS
PRODUCT TO ANY RETAIL STORE!
For any questions or problems with this product please contact us at:
Email: info@interactivetoy.com
Phone: Inside North America: +1 416 444 6873
Outside North America: 1-866-214-2220
Address: Interactive Toy Concepts 1192 Martin Grove Road, Toronto, Ontario, Canada. M9W 5M9
IMPORTANT SAFETY INFORMATION
The Polaris RUSH is a sophisicated model and should be treated as such. Improper use could cause damage to you, bystanders and/or property.
Please follow all saftey precautions and assembly instructions listed in this manual and use common sense when operating the model.
Note that the Polaris RUSH is electric powered and that electricity and water do not “mix” well. While the snowmobile is snow-resistant,
it is not waterproof. Keep it out of wet snow, rain and away from puddles. Otherwise you may seriously damage your machine.
Basic Safety: Do not modify the snowmoblie or radio; this will void your warranty • Test your snowmobile before every use and clean any packed
snow out of the drivetrain area • The Polaris RUSH is designed to be used on packed, flat snow only. Do not attempt to use the sled in powder
or on rough or broken snow as it may fall into ruts and holes or hit snow-boulders. damage to your sled may result. • Always use your sled
in large open areas only. Do not operate your model near people, cars, buildings, trees or other obstructions. • Ensure the the transmitter has a fresh
battery and onboard battery pack is fully charged before operating your model. • Always range-check your transmitter prior to every session.
IMPORTANT BATTERY INFORMATION
Use only batteries recommended in this instruction manual. Do not mix old and new batteries.
Battery installation should be performed by an adult. Be careful to install the batteries with the correct polarity, as indicated.
Do not use rechargeable batteries. Do not mix alkaline, standard, lithium, rechargeable, or different types of batteries.
The supply terminals are not to be short-circuited. Exhausted batteries are to be removed as they will hinder performance.
Never leave a battery unattended while it is being charged. Never leave a battery
unattended in the presence of children. The snowmobile takes one 9V battery (not included).
FCC NOTE: U.S. ONLY
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference in a
residential installation. This generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver - Connect the equipment
to an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help.
Polaris
®
are registered trademarks of Polaris Industries Inc. used under license to Interactive Toy Concepts Ltd.
Conforms to Safety Standards ASTM F963-03 Regulatory Requirements. Products and colors may vary. MADE IN CHINA.
INS-42500-170709-ENG
This radiocommunication device complies with all the requirements of Industry Canada Standard RSS-310.
Operation is subject to the following two conditions: 1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Field Strength and measurement distance: 27.195MHz –
60.49 dBµV/m
at 3 meter. 49.890MHz - 61.61 dB
µ
V/m at 3 meter.
Industry Canada Notice: Canada only.
Transmitter
Ni-Cd Rechargeable
Batteries must be
recycled or disposed
of properly.
Limited 30-day warranty
Product is warranted by Interactive Toy Concepts Limited against manufacturing defects in
material and workmanship under normal use for (30) days from the date of purchase.
Warranty is validated upon receipt of proof or purchase and confirmation of UPC code.
Proof of Purchase
Working
Head Light
Scale Styling
& Decals
Battery
Compartment
Ski’s
Drive Track
Working Front & Rear
Suspension
Mounting Point
Take care to ensure snowmobile antenna has been detached from packaging before removing the snowmobile.
RC
Antenna
Battery
Compartment
Compartment
Wall Adaptor
(120V AC in)
Battery
Connector
9.6V 600 mAh
Ni-Cd Battery
Battery
Connector