Filter
Top Products
92
MAINTENANCE
Cleaning Intake Water Drain Valve
1. Raise the cargo box.
2. An air intake water drain valve is located below the
pre-filter that should be inspected and clean at the
same time the pre-filter is cleaned.
3. Remove dirt and debris from the valve and squeeze
the valve to make sure it is not plugged. If any
damage is found, replace the drain valve.
Hydraulic/Hydrostatic System
Checking Fluid
WARNING! Always clean up spilled fuel or oil. Keep heat,
flames, sparks or lighted tobacco away from fuel and oil.
Failure to use care around combustibles can cause explosion
or fire.
1. Use only recommended fluid in the hydraulic system.
2. Park the utility vehicle on a flat level surface,
lower the attachment arm and put the attachment
flat on the ground. See page 42.
3. Move the gear selector lever to Park, stop the
engine and exit the utility vehicle. See page 40.
4. Raise the cargo box. See page 57.
5. Check the fluid level in the sight gauge. The fluid
level is correct when at the center of the sight
gauge.
6. Use only recommended POLARIS hydraulic fluid
when adding or changing the hydraulic fluid. See
page 119.
Adding Fluid
1. Clean the area around the fill cap.
2. If needed, remove the fill/breather cap and add fluid.
3. Lower the cargo box. See page 57.
Water Drain Valve
Sight Gauge Fill Cap