Filter
Top Products
79
MAINTENANCE
Lubrication Recommendations
Check and lubricate all components at the intervals outlined in the Periodic Maintenance
Chart beginning on page 73, or more often under severe use, such as wet or dusty conditions.
Items not listed in the chart should be lubricated at the general lubrication interval.
Start Interlock System
The utility vehicle is equipped with a Start Interlock
System. The following must be in place before the
Utility Vehicle can be started:
• The gear selector lever must be in Park, Neutral, or
the treadle pedal must be in neutral
• PTO must be OFF (If Equipped)
Inspection
To check the function of the Start Interlock System,
preform this procedure in an open area on flat level
ground and make sure the area is clear of bystanders.
1. With the gear selector lever in low gear and the
PTO OFF, move the treadle pedal to the forward
travel position, the engine must not start. Repeat
the procedure with the gear selector in High and
moving the treadle pedal into the reverse direction.
2. With the treadle pedal in neutral and the gear
selector lever in PARK, move the PTO to the ON
position, the engine must not start.
3. If the engine starts in any of these positions, see
your dealer for service.
Item Lube Method
Engine Oil See page 82-83
Brake Fluid DOT 4 Brake Fluid Maintain level between fill lines. See page 96.
Main Gearcase Oil
(Transmission)
AGL Gearcase Lubricant &
Transmission Fluid
See page 84.
Front Gearcase Oil Demand Drive Fluid See page 85.
Front Prop Shaft Yoke
and PTO shaft
U-Joint Grease Locate fittings and grease (3 pumps maximum).
See page 114.
Front and rear
suspension
U-Joint Grease Locate fittings and grease (3 pumps maximum).
See page 114.
Lever
Control Pedal
PTO