Polaris 300 4X4 Offroad Vehicle User Manual


 
120
TROUBLESHOOTING
Drive Belt Wear/Burn
Possible Cause Solution
Driving onto a pickup or
tall trailer in high range
Use low range (if equipped).
Starting out going up a
steep incline
Use low range (if equipped) or turn around using the K-
turn (see page 60).
Driving at low RPM or
ground speed (3-7 MPH)
Drive at a higher speed or use low range (if equipped)
more frequently.
Insufficient warm-up at
low ambient tempera-
tures
Warm the engine at least 5 minutes. With the transmission
in neutral, advance the throttle to about 1/8 throttle in
short bursts, 5 to 7 times. The belt will become more flex-
ible and prevent belt burning.
Slow/easy clutch engage-
ment
Use the throttle quickly and effectively.
Towing/pushing at low
RPM/low ground speed
Use low range only (if equipped).
Utility use/plowing Use low range only (if equipped).
Stuck in mud or snow Shift the transmission to low range (if equipped). Care-
fully use fast, aggressive throttle application to engage
clutch. WARNING: Excessive throttle may cause loss of
control and vehicle overturn.
Climbing over large
objects from a stopped
position
Belt slippage from water
or snow ingestion into the
PVT system
Dry out the PVT. See page 101. Inspect clutch seals for
damage if repeated leaking occurs.
Clutch malfunction See your Polaris dealer.
Poor engine performance Check for fouled plugs or foreign material in gas tank or
fuel lines. See your dealer.
Slippage from failure to
warm up belt
Always warm up the belt by operating below 30 mph (48
km/h) for one mile (1.6 km). Operate 5 miles (8 km) or
more when temperature is below freezing.
Wrong or missing belt Install the recommended belt.
Improper break-in Always break in a new belt and/or clutch. See page 48.