Filter
Top Products
KIT COMPONENTS
Rear
Support
Bullet
4 5
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Screw the Rear Support
Bullet onto the bolt on the back of the aftermarket
head unit ("A"). Mount the radio/kit assembly to
the sub-dash with those screws previously
removed in step #1.
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
3
99-3042
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
CHEVROLET
Blazer 1986-93........................................................... 2
Camaro 1982-92......................................................... 1
S-10 Pickup 1986-93................................................... 2
GMC
Jimmy 1986-93...........................................................2
S-15 Pickup 1986-93................................................... 2
PONTIAC
Firebird 1982-92......................................................... 1
SATURN
(All models) 1991-94...................................................2
TOOLS REQUIRED
Cutting tool
Socket wrench
Phillips screwdriver
Torx-head screwdriver
KIT FEATURES
Shaft and
DIN unit
provisions
Rear support
provisions
ALL VEHICLES
2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft
nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the shaft supports from the Radio Housing. Slide the
DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket
head unit into the cage until secure. (see Fig. B)
3
Fig. B
Fig. A
"A"
Radio Housing
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 290601