Mattel M4552-0920 Motorized Toy Car User Manual


 
4
7
1.
2.
3
5
6
GO
To Play
CHARGE THE CAR
Press and hold the car on the charger. Hold for approximately 10
seconds to get a good charge. Run the car until it needs recharging.
5
POWERBURST FIGURE 8POWERBURST FIGURE 8POWERBURST FIGURE 8
CONTENTS
TRACK SET TR
A
CK SET
TRACK SET
INSTRUCTIONS
INSTRUCTIONSINSTRUCTIONS
M4552-0920
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressively approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
Mattel, Inc., 333 Continental Blvd., El Segundo, CA 90245 U.S.A. Consumer Relations 1 (800) 524-8697
service.mattel.com. Mattel Canada Inc., Mississauga, Ontario L5R 3W2. You may call us free at/ Composez sans
frais le 1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB.
Mattel Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135 312.
Mattel East Asia Ltd., Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran
Tropicana Golf Country Resort, 47410 PJ. Tel:03-78803817, Fax:03-78803867.
SPEED RACER MOVIE: © Warner Bros. Entertainment Inc. SPEED RACER: ™ Speed Racer Enterprises, Inc.
(s08)
© 2007 Mattel, Inc. All Rights Reserved.
INSTRUCTION SHEET
SPECIFICATIONS
Toy:
Toy No.:
Part No.:
Trim Size:
Folded Size:
Type of Fold:
# colors:
Colors:
Paper Stock:
Paper Weight:
EDM No.:
SR
M4552
0920
33"W x8.5" H
5.5" W x8.5" H
accordian
2C + 2C
PMS 485C + Black
White Offset
100 lb.
• This product is not recommended for use on loose dirt or
wet surfaces.
• Do not immerse in water.
• Only use charger supplied with this toy.
• Do not use any other charging source.
• Do not attempt to hold wheels while charging. Wheels must
spin during charging period.
• During charging, the vehicle may cause radio or television
interference. If so, move the vehicle away from the item
being interfered with.
• Do not attempt to recharge a charged vehicle. Additional
charging will not increase running time.
• Do not recharge the vehicle if it feels hot. Allow it to cool
before recharging.
• Do not attempt to use or charge the vehicle if it shows
signs of leakage or corrosion. If the vehicle and /or charger
get wet, discontinue use until they are completely dry.
Thoroughly wipe off all moisture and allow to air dry
completely before use.
!
CAUTION: To prevent entanglement,
keep hair away from wheels.
CAUTION: Vehicle contains a rechargeable cell.
if fluid leaks, avoid contact with eyes and
discard vehicle.
!
Squeeze in ends of track at each connection.
Spread out opposite ends as shown.
TRACK TIPS FOR BEST RACE ACTION
SPREAD ENDS OF TRACK
LEADING OUT OF CURVE
SQUEEZE ENDS OF TRACK
LEADING IN TO CURVE
J1
M2
x 2
x 2
F1
F2
F1
F2
F1
F2
F1
F2
F1
F2
F1
F2
C1
C2
D1
D2
E1
E2
B1
B2
A1
A2
J1
J2
K1
K2
x 2
Q1
Q2
N1
N2
M1
M2
L1
L2
C1
C1
C1
C2
E1
E2
D1
D2
J1
K1
M2
L2
C1
D1
A2
B1
A1
A2
Q1
Q1
Q2
Q2
N1
N2
B1
B2
2
Q1
Q2
1
F1
F2
F1
F2
F1
F2
J1
J2
M1
M2
F1
F2
F1
F2
F1
F2
K1
K2
L1
L2
K1
L2
Keep these instructions for future reference as they contain important information.
Requires 3 “AA” (LR6) alkaline batteries. Batteries included are for demonstration purposes.
Refer to numbers on parts and contents page to help with assembly.
M4552-0920 Size: 8.5” x 33” Color: 2C + 2C
ASSEMBLY
FINAL ASSEMBLY
3.
SKID LEVER
SKID LEVER
Press the skid levers on
either side of the track
and try to knock off your
opponent.
Battery Installation / Replacement
Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check your
local authority for recycling advice and facilities.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that
can cause a chemical burn injury or ruin your product. To
avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the
product before being charged (if designed to be
removable).
• Rechargeable batteries are only to be charged under
adult supervision (if designed to be removable).
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries
inside may explode or leak.
Remove battery cover with a Phillips head
screwdriver (not included). Remove batteries
included for demonstration purposes and
dispose of them safely. Insert 3 new "AA" (LR6)
alkaline batteries in the orientation shown.
Replace battery cover and tighten screw. For best
performance use only alkaline batteries. Replace
batteries if booster no longer propels cars
through the set.
BOTTOM VIEW