Filter
Top Products
Changing the Destination Leg of an Active Route
When a route is created it can have many different legs to it, each leg with its own
destination. If during your travels you want to skip some of the legs, you can select the leg
that you want to proceed to next.
An example would be that your planned route starts at your campsite. The first leg goes to
the bridge. The second leg goes across the bridge to the stone marker. Leg 3 leaves the
stone marker and takes you to the ranger station. To finish out the route, the final leg goes
from the ranger station to the swimming area. This route would be Camp > Bridge > Marker
> Ranger > Swim. Suppose that after crossing the bridge you don’t want to go to the stone
marker but instead you want to go to the ranger station. Because the route is active (you can
select legs only from active routes), you would follow the instructions below and tell the
eXplorist to set the next leg to the ranger station. The route would be recomputed,
eliminating the navigation instructions to go to the stone marker.
1. Press MENU.
2. Use the Arrow joystick to highlight Routes.
3. Press ENTER.
4. Use the Arrow joystick to highlight the active route.
5. Press MENU.
6. Highlight Select Leg.
7. Press ENTER.
8. Use the Arrow joystick to highlight the next destination POI
from the route list that you want to go to. In the example to
the right, that would be Ranger.
9. Press ENTER.
10. Confirm that you want to do this by using the Arrow joystick
to highlight Yes.
11. Press ENTER.
12. Press NAV to return to the last viewed navigation screen.
Routes
38
Enter to Select
Camp
Bridge
Marker
Ranger
Swim
Leg
Bearing
Distance
3
272° 3.06
M
M
I
Route leg list with Ranger
selected. Note that
Marker is bold because it
is the current active leg.