Open as PDF
To get to the GPS Simulator:
2. Press ↓ to
. The GPS Simulator Menu appears.
GPS Setup Menu, left; GPS Simulator menu, right.
Make the desired settings, then turn the simulator on by highlighting
box and pressing
to erase this menu. A message and tone appears periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the GlobalMap 3200 off.
While in simulator mode, you can press
to clear the steering and
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
, then Press
to return to the previous page.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
(shown in compass degrees) that will point you toward the start
of the trail/route.
to zero. Select
command and press
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
to clear the alarm.) When navigation starts,
press ↑ to increase speed to the desired setting.