Lowrance electronic 10770001 GPS Receiver User Manual


 
| 93
Radar | Lowrance HDS Gen2 Touch
Radar installation menu
Setup and configuration of the Broadband radar has been simplified
compared to traditional pulse radars. There is no zero range (time
delay), no warm up time, and no burn-in required.
Radar status
Displays scanner information, the availability and status of scanner
features, and the status of radar peripherals.
Adjust bearing alignment
This is to align with the heading marker on the screen with the
center line of the vessel, this will compensate for any slight mis-
alignment of the scanner during installation. Any inaccuracy will be
evident when using MARPA or chart overlay.
Point the boat to be perpendicular to the very end of a breakwater
or peninsula. Adjust the bearing alignment setting, so that the
heading marker and land mass intersect.
Adjust range oset
Eliminates the time lag between real radar returns and the time it
takes data to be processed by the radar software. Range offset is
also referred to as zero range and trigger delay.
Adjust antenna height
Set the radar scanner height. The Radar uses this value to calculate
the correct STC settings.
Tune
Adjustments to this setting should only be performed by a trained
radar technician.
Sidelobe suppression (Broadband radar only)
¼ Note: This control should only be adjusted by experienced radar
users. Target loss in harbour environments may occur if this control is
not adjusted correctly.