Filter
Top Products
ENGLISH
10
GENERAL TIPS AND WARNINGS FOR STARTING THE MOTORCYCLE
»
Instructions for the first ride
– Make sure the work for the „pre-delivery inspection“ was per-
formed by your authorized KTM workshop. The DELIVERY CER-
TIFICATE and SERVICE MANUAL will be handed over when you
pick up your vehicle.
– Before your youngster takes his or her first ride, explain how
each of the controls works and check if your youngster has under-
stood what you explained. We recommend to review the entire
owner’s manual with your youngster item by item, paying par-
ticular attention to the specially marked warnings and point-
ing out the danger of injury.
– Adjust the clutch lever, hand lever and foot brake pedal so your
child can operate them easily!
– To prevent injury, teach your youngster the basic riding skills
on soft ground, e.g. on a meadow or in the garden. Be sure that
there is room enough to maneuver, and that no other riders are
close.
– To ensure that your youngster gets the feel of the hand brake,
have your youngster operate the hand brake while you push the
motorcycle. Do not start the engine before your youngster has
learned to apply hand brake with appropriate pressure.
– To familiarize your youngster with the operation of the hand
brake let him or her practice to operate the hand brake while
you are pushing the motorcycle. Do not start the engine before
he or she is thoroughly familiar with the use of the hand brake.
– Initially, your youngster should ride back and forth between two
persons who help the young rider to stop the motorcycle.
However, you should also teach your youngster how to stop the
motorcycle himself/herself.
– To improve his/her riding skills, your youngster should practise
riding the motorcycle standing on the footpegs or to riding at
the slowest possible speed. Additionally, you can arrange a series
of obstacles and have your youngster drive around them, etc.
– Pay attention to the running-in procedure.
Running in
– Even very precisely machined sections of engine components
have rougher surfaces than components which have been slid-
ing across one another for quite some time. Therefore, every
engine needs to be broken in. For this reason, during its first
30 minutes the engine must not be revved up to its perform-
ance limits.
– Apply low but changing loads for running-in.
Do not drive at full load for the first 30 minutes!
– Have your youngster wear proper protective gear whenever he
or she rides the motorcycle: helmet, eye protection, chest,
back, arm and leg protectors, gloves and boots. To set a good
example, be sure to wear protective gear yourself whenever rid-
ing a motorcycle!
– Only use accessory parts recommended by KTM.
– The front and rear wheel are only allowed to be tired with tires
that have the same profile type.
– Your youngster's driving speed should always be adjusted to his/her
driving skills as well as to the terrain.
– Your youngster should never be allowed to ride the motorcycle
without supervision.
– Replace the helmet visor or goggle glasses early enough. When
light shines directly on a scratched visor or goggles, you will
be practically blind.
– Never leave your motorcycle without supervision as long as the
engine is running.
– SX models are designed for one person only. Passengers are
not allowed.
– These models do not comply with the regulations and safety
standards established by the law. Therefore, they are not per-
mitted on public roads.
– Always keep in mind that other people feel molested by exces-
sive noise.