KTM 50 SX PRO SENIOR LC Motorcycle User Manual


 
ENGLISH
24
Tires, air pressure
Tire type, tire condition, and air pressure level affect the way your motor-
cycle rides, and they must therefore be checked whenever you are getting
ready to go anywhere on your motorcycle.
Tire size can be found in the technical specifications.
Tire condition has to be checked every time you want to ride your
motorcycle. Before leaving, check tires for punctures and nails or other
sharp objects that might have become embedded in them.
Regularly check the "cold" tire pressure. Correct tire pressure (1.0 bar /
14 psi) guarantees optimum grip and maximum tire life.
ƽ
WARNING
ƽ
–D
AMAGED TIRES MUST BE REPLACED IMMEDIATELY TO PROTECT YOUR YOUNGSTER.
–W
ORN TIRES CAN HAVE A NEGATIVE EFFECT ON HOW THE MOTORCYCLE PERFORMS,
ESPECIALLY ON WET SURFACES
–TIRE PRESSURE BELOW THE NORMAL LEVEL WILL LEAD TO PREMATURE TIRE WEAR.
Checking spoke tension
The correct spoke tension is very important for the stability of the wheels
and thus for riding safety. A loose spoke causes the wheel to become
unbalanced and before long other spokes will have come loose. Check
spoke tension, especially on a new motorcycle, at regular intervals. If neces-
sary, have the spokes retightened and the wheel centered by a KTM dealer.
ƽ
WARNING
ƽ
S
POKES CAN TEAR IF YOU CONTINUE TO RIDE WITH THEM LOOSE
. T
HIS MAY LEAD TO AN
UNSTABLE HANDLING OF YOUR MOTORCYCLE
.
–EXCESSIVELY TENSIONED SPOKES MAY RUPTURE DUE TO LOCAL OVERLOADING. THE
SPOKES MUST BE TENSIONED TO
2,5 - 3 NM.
Cooling system
The water pump 1 in the engine keeps the cooling liquid in circulation.
The cooling liquid is cooled by the air stream. Therefore, the cooling effect
is reduced when the traveling speed is reduced. Dirty radiators additionally
reduce the cooling effect.
The cooling liquid can be drained by removing screw
2 on the water-pump
cover.
ƽ
WARNING
ƽ
D
O NOT REMOVE ANY COOLER HOSES OR THE DRAIN SCREW WHEN THE ENGINE IS HOT.
A mixture of 40% antifreeze liquid and 60% water is used as coolant.
How-ever, the antifreeze protection must be at least -25° C (-13° F). This
mixture offers antifreeze protection but also good corrosion protection and
should therefore not be replaced by pure water.
!
CAUTION
!
F
OR THE COOLING SYSTEM, USE ONLY WITH HIGH-GRADE ANTIFREEZE (SHELL ADVANCE
COOLANT). USING LOWER-GRADE ANTIFREEZE AGENTS CAN CAUSE CORROSION AND
COOLANT FOAMING
.
Pressure induced by heating of the coolant in the system is controlled by a
valve in the radiator cap 3; a water temperature rising up to 120° C (248° F)
is admissible without fear of problems.
1
3
2